slop in lower control arm torsion socket.

General Discussion

  1. Ironracer

    Ironracer Gearhead

    Messages:
    2,649
    Likes Received:
    1840
    Joined:
    May 8, 2020
    Location:
    Tampa Bay Florida
    Local Time:
    5:28 AM
    By the time I cut through the welds, and popped them with a cold chisel n baby Sledge, they were tight, side to side, with some resistance, up and down. Before he welded them. When I hold the arm and grab the end of the pin with the nut, there is 3/8 there...
     
    Last edited: Jul 25, 2021
  2. RustyRatRod

    RustyRatRod I was born on a Monday. Not last Monday. FABO Gold Member

    Messages:
    79,623
    Likes Received:
    58144
    Joined:
    Jun 7, 2010
    Location:
    Georgia
    Local Time:
    5:28 AM
    Send it.
     
    • Thanks! Thanks! x 1
    1. This site uses cookies to help personalize content, tailor your experience and to keep you logged in if you register.
      By continuing to use this site, you are consenting to our use of cookies.