Jason Holt
Active Member
I have a 67 dart gt that I did the front brake disc conversion and rear disc conv from doctor diff. I replaced the master cylinder with one he recommended. I pumped all the air out of the master cylinder. Connected the lines used a motion brake bleader kit and ran a couple quarts through the system. I’m not getting any more air out of the lines. This is a power brake system. When I push on the pedal it doesn’t stop until the floor. The second time I push it down it stops halfway. The third time I push it it’s right at the top and feels great. Then if I wait 5 seconds and push it again it doesn’t stop until the floor. What is wrong? Please help!