Stop in for a cup of coffee

-
Hey know what I need Mike if you know of where to even look for it a yellow plastic tube that I can take a piece of and melt over the terminal end of a mopar distributor lead, Using a straw from Hobby Lobby right now but it is just not right. I can find a pic if you do not know what I mean.
I know what you are doing, a yellow plastic spoon is the right kind of plastic, I have a few old models, if I can find any yellow plastic I will be glad to send it to you
 
I would love to find a 74 4 door model, never found one. I would send it to someone that can do them properly though, not my thing.
I've got a buddy that does 3D printing....... just have to get an accurate 3D model drawn up
 
you need heat shrink or a plastic to melt and mold Hops ??
 
I have been using these but the color is way off, looking for a tube that can go over the wire then heated up and slip over the terminal.
81m9bYHrNEL._SY355_.jpg
 
Dam ben almost spit out my coffee! You just got the daily chuckle.

George! you get lost or was the Alzheimer's kicking in?
 
Just got done reading the news report on the perpsicle from last night. Cops tried to pull him over for suspected drunk driving, he took off at speeds reaching over 100 mph.... but ran out of gas apparently and ditched the vehicle, tried to walk across the thinly frozen river, fell thru the ice but managed to get out and onto the other bank, cops found him later up against a tree with extreme hypothermia setting in. So he's in the hospital in critical but stable condition. Come to find out, he had multiple warrants for his arrest, all drug related.
 

Might have to set up the clay thrower again this year, the Squirrels are getting thick here. I put some food on it then launch them on the frozen pond, pretty funny and the Harley loves it!
 
-
Back
Top Bottom