Forgot to post this picture of my dual sinks, only cold water supply, never said I was an artist or plumber
View attachment 1716069743
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Good Morning everyone. Got another patch panel in the Charger. Floor/firewall section. Man I need the rollers for smaller wire for my welder. What a PIA when using too big of wire on not just sheet metal, but old crappy metal.
Icetech
Well-Known Member
Yup, i use .023, it's great for trying to get thin metal/rust to stick together
My rollers have two groves dont yours?
Yes 0.030 and 0.035 I believe. I need the smaller ones
Got ya .023?. I only run 30 and 35.
Yes, something between 0.020 and 0.25 ideally. see what miller has
I got a great welder from OMR the thing is a beast. Has a ton of options I never saw before like stich and spot setting. Pretty cool so far.
I have a very nice Miller XMT304. Mig/tig/stick inverter welder. 400A capacity. Can weld anything I desire except aluminum as the AC kit is expensive...or was
Unconventional
Well-Known Member
It's Tacoma Tuesday!
Good morning
Good morning
Morning, 7deg outside this morning, walk was a little brisk. Where's the coffee?
A little clean up to do but this will work well. Hey, I can see my computer screen!
Let that beuityful sun shine in, out in the shop plumbing my sinks in, well, the wife's sinks ..
$130
$190
my bum hurts…
Unconventional
Well-Known Member
Had to use
Trying to recall what I paid for my tank...but it was about that and not as large as yours. (Does that mean I have inert gas envy?)
Icetech
Well-Known Member
Mines a 62 b-body should have room, i posted on the other forum to find out.. no way i'm cutting my hood
I think im winning. Copied my music from my old iphone into media player, and it seem to accept it into itunes, copying now. I really want all of my 8 gigs of musiccin my current phone
Not a fan of those. One backfire and melted foam goes down the carb and into the engine. I have seen it happen a few times.
-
Similar threads
