Tacfire11
Strike Hard, Strike Deep
Hey everyone, frustrating afternoon. Finally got enough free time to try and mate the 727 to the 440, and it didn't fit. The Bell Housing stands off about 1/2 - 3/4" from the engine. The Bolt holes line up perfectly, and the Converter is inserted all the way into the Trans input shaft, but when I tighten them can't pull the transmission in any closer than 1/2" Obviously these didn't come out of the same car, and think this may be have mated to the 400 before.
Any suggestions, are there spacer plates available?
Thanks
Pat
Any suggestions, are there spacer plates available?
Thanks
Pat