Brian c
Well-Known Member
I have a 73 dart, firm feel 1'' bars and tti step headers, with a small block. I put my headers on and went to install the drivers torsion bar and its tight up against #7 pipe. I called TTI and they said that i would have to modify my motor mounts to move my engine over. I have spool mounts so i dont think i can shim them. Anyone else have or heard of this problem? is there any simple solution? any suggestions of how i can modify my mounts? I dont know the make of my mounts and im pretty sure they are a ebay buy, kinda wonder if they could be the problem?
Any info appreciated, thank you!!
Any info appreciated, thank you!!