tti race headers hitting steering box and steering joint

[SR77]

Any ideas or recommendations, dimple the header and shave the joint ? Not sure about steering box either.
It's a demon with a 340 and auto trans.

 

[CudaChris67]

mine dropped in no problem, manual steering, 340 on spool mount with auto. Did you already follow the tti instructions for centering the engine and moving the shift linkage?
[ame]http://www.ttiexhaust.com/PDF/II_TTI340A.pdf[/ame]

 

[SR77]

its at a shop getting installed, i get on my back and my vertigo kicks in (get insanely dizzy) i asked them if they measured the get it centered and have a set of schumacher engine shims coming.

 

[SRT_DSTRHOLC]

Ya mine hit box, ground bolt down. Hit idler arm, ground it and still hits sometimes. I gave up. Next time i go dougs

 

[autoxcuda]

You said TTI race headers. What is the tube diameter and part number?

There's a lot more that one set of TTI headers for a small block.

 

[EL5DEMON340]

Mine hit in the same spots 71 demon, they could be better for the money that's for sure.

 

[roccodart440]

You can slide the column to the outside if you loosen the bolts in the firewall. Loosen the 3 bolt plate. If you open up the holes it will go even further.

The steering box can be moved as well using the same process.