abodyjoe
Well-Known Member
here is cap crap...
Tubular K Frame Identification
- Thread starter Beams
- Start date
-
Mike67
Well-Known Member
Look at their reviews, many comments on failed welds. May want to look at adding some gussets to help strengthen some of those areas especially where the angles are exaggerated, anything welded less than perpendicular is a weak point just through the physics of it all. Look at roll cages that have odd intersecting angles, any reputable chassis builder installs gussets.
That being said if you do your due diligence you should be ok.
That being said if you do your due diligence you should be ok.
Last edited:
famous bob
mopar misfit
Sure dont look like mine !
abodyjoe
Well-Known Member
Your what?
famous bob
mopar misfit
lol-----k frame !
abodyjoe
Well-Known Member
What are you running?
famous bob
mopar misfit
THE EARLY MAG. FORCE TUBULAR RACE SET UP -----no troubles w/ it for 10ish yrs, on the street-
just replaced the rack and pinion and outer heim joints on the tie rods -
my success w/ it is probly because the engine is on a motor plate , and not the k frame -------??
abodyjoe
Well-Known Member
famous bob
mopar misfit
Or just dumb luck.
Well luck hasnt always been with me , he`s kind of a stranger around HERE !
Might be , I got a good one , ever think of that ?
abodyjoe
Well-Known Member
-
