cybrtygr32
1967 Ratfish Fastback
Hey guys, I need help. I asked this same question to Denny's drive shaft and they told me no such animal was made. Here is my plight:
7 1/4 rear trashed in my 67 Barracuda Fastback with 273 engine. I had a excellent 8" Granada rear that bolts right in place (I'm changing to 15" steelies and Duster brakes in front). Drive shaft length is good. I need a u joint that will mate the plymouth drive shaft to the 8" rear. The bearings on the Cuda shaft are darn close, but I don't won't close at 70 mph! It seems as though I've seen a post where someone had done this and their u joint was a NEAPCO 2-3100, but not sure. Somebody jump in here and tell me what I need other than a welded up shaft. I know, I know, a Ford in Mopar, I'm an old street rod guy and I have done worse! (chevy in a ford).
7 1/4 rear trashed in my 67 Barracuda Fastback with 273 engine. I had a excellent 8" Granada rear that bolts right in place (I'm changing to 15" steelies and Duster brakes in front). Drive shaft length is good. I need a u joint that will mate the plymouth drive shaft to the 8" rear. The bearings on the Cuda shaft are darn close, but I don't won't close at 70 mph! It seems as though I've seen a post where someone had done this and their u joint was a NEAPCO 2-3100, but not sure. Somebody jump in here and tell me what I need other than a welded up shaft. I know, I know, a Ford in Mopar, I'm an old street rod guy and I have done worse! (chevy in a ford).