grassy
Well-Known Member
I sometimes wonder if the folks writing instructions on how to install a part have ever seen one in person. Did a search here and again, read the service manual which is clear as mud...either that or I am getting a little less smart in my older age
I bought these from Energy suspension.
They will not fit into the holes without a bit of grease and a push.
It seems that I am supposed to take them apart ( how ? ) and have done a bunch of measuring before I took the arms off the car (oops).
I have read about an alignment tool ..not sure where an have watched a guy wiggle the control arm in a youtube video. Nothing is mentioned about the funny looking bolts and washers that I took off the car.
I thought that you just pop them in...check for slack, add a washer or two if required and use the funny looking bolt and washer..maybe a lock nut washers as well and tighten it up.
Shouldn't the holes that you install the ends in keep the alignment ?
Am I missing something ?
Lastly, an anyone identify the following kit ?
As always, thanks for your input.
Ian
I bought these from Energy suspension.
They will not fit into the holes without a bit of grease and a push.
It seems that I am supposed to take them apart ( how ? ) and have done a bunch of measuring before I took the arms off the car (oops).
I have read about an alignment tool ..not sure where an have watched a guy wiggle the control arm in a youtube video. Nothing is mentioned about the funny looking bolts and washers that I took off the car.
I thought that you just pop them in...check for slack, add a washer or two if required and use the funny looking bolt and washer..maybe a lock nut washers as well and tighten it up.
Shouldn't the holes that you install the ends in keep the alignment ?
Am I missing something ?
Lastly, an anyone identify the following kit ?
As always, thanks for your input.
Ian