Muscley MOPAR
Well-Known Member
anyone have roller bearing washers inbetween their shaft mounted rocker arms on a w2 head...if so does anyone know where i could find them
I have only seen metal spacers or springs for the wide spaces and thin steel shims for the fine tuning to center the rocker arm.
I have only seen metal spacers or springs for the wide spaces and thin steel shims for the fine tuning to center the rocker arm.
good call on that.It dont take much to get thos little rollers out of there....ArtieThey may have been used by someone before, maybe on another brand with shaft mount rockers? But in my opinion any advantage friction or durability wise, if there is any at all, would be offset by the risk of failure. That's a lot of little needles that could end up in the pan, or worse.
i hear what yours saying, but theres also the possibilty of a hardened washer against the rockers puting shavings in from the friction...in my experience the less friction on something the less stress and by putting those needle bearings in there it reduces friction and drag...but hey im no physicist
hey thanks rick hopefully the worst thing thatll happen is get some needles in my pan or trapped in the pick up tube