Articles by Dana67Dart

67 Dart Grab center medallion cap and twist counter clockwise while holding the horn ring and steering wheel from turning. On 69 Dart with padded horn ring Place a small screwdriver between medallion and horn ring on driver's side of medallion (9:00 position) and pry up. Go easy and you...

NOTE: Many of the photos differ from the the description, as I was using materials I had on hand. Purchase 2 12x12x40 lamp boxes from U-Haul Assemble one box leaving the top open Use fiber reinforced tape on all edges and along and across the bottom Cut two plywood squares to fit into the...

How to install reproduction headlight adjusters into a front fender Compare Reproductions to OE (Other than color they look good, bought from Classic Ind.) Remove screw Slide metal part up off of plastic part (This allows for the plastic part to compress as it goes into the slot in the...

Tools / materials needed: · Faucet Puller Husky Compression Sleeve and Faucet Puller-63876 - The Home Depot · Roll pin Punch Set Roll Pin Punch Set (9-Piece)-61135 - The Home Depot · 3"x3"x3" block of wood, preferable hard wood like Oak, but Fur or Pine 2x4 will work 1. Cut a block of...