Steering, Suspension & Brakes
-
Torsion bar install
- bryan Schaupp
- 2 min read
- Views: 7K
- Reaction score: 3
I read a lot of conflicting information prior to changing to the 1.03 Bars. When all said in done it was pretty easy, Here are steps I used: 1... -
How To Save $150
- RustyRatRod
- 1 min read
- Views: 5K
- Reaction score: 16
This is for people with more sense than money. Most of us know, when you upgrade leaf springs, you change the front hanger bolt diameter to 5/8"... -
How to Restore a Mopar A-Body Steering Column
- Ag1753
- 1 min read
- Views: 9K
- Reaction score: 3
Go to YouTube and watch this video: This video will show you how to restore an A-body steering column. It includes, removal, disassembly... -
In Place Parking Brake Handle Replacement
- Dana67Dart
- 2 min read
- Views: 4K
- Reaction score: 3
Tools / materials needed: · Faucet Puller Husky Compression Sleeve and Faucet Puller-63876 - The Home Depot · Roll pin Punch Set Roll Pin Punch... -
Steering Coupler Rebuild "How To"
- Cuda Al
- 2 min read
- Views: 16K
- Reaction score: 10
Since it regularly comes up I felt it was time to do a write-up on how to rebuild the steering coupler. In my opinion the column needs to be... -
Refurbishing Upper Control Arms (UCA)
- MObarracuda
- 7 min read
- Views: 11K
- Reaction score: 2
This how to article is my way of saying thank you to everyone who shares their time, talents and posted on this site. I have benefited so much... -
How To: Saginaw Power Steering Pump Rebuild
- MrJLR
- 1 min read
- Views: 10K
- Reaction score: 5
Pretty darn simple Mopar in it's natural state Disconnect the battery. ..always. Pull the pump. 2 hoses and 2 bolts. The tensioner bolt goes... -
How to Remove and Install the Bushes in the Upper & Lower Control Arms
- Tom Bishop
- 1 min read
- Views: 9K
- Reaction score: 5
Here is a little presentation I done on how to replace the Upper and Lower Control Arm Bushes. This is based on my own experiences and trials of... -
Finally...LCA bushing videos...
- Jim Lusk
- 1 min read
- Views: 5K
- Reaction score: 6
After years of saying that I would make the videos on the removal and installation of Mopar lower control arm bushings, I finally did. It's only... -
How to: Dual Brake Circuit System Install on Early A Body
- AW-100
- 2 min read
- Views: 10K
- Reaction score: 17
My 1965 Plymouth Barracuda came with single circuit brakes. Here's how I converted the old girl to dual circuit. Old single circuit MC. I... -
How to Build Modern Traction Bars
- Joeychgo
- Updated
- 9 min read
- Views: 16K
- Reaction score: 12
Traction devices have been around for years. Perhaps the best known are the classic "traction bars" that bolt to the bottom of the springs and /... -
The Kelsey-Hayes Disk Brake Swap Thread
- 57dodged100
- 8 min read
- Views: 27K
- Reaction score: 19
The Kelsey-Hayes disk brake swap is popular and there is lots of information on FABO about this swap, but I decided to make a post to centralize... -
How To Replace your Lower Column Bearing: Better and Cheaper!!!
- 72bluNblu
- 2 min read
- Views: 33K
- Reaction score: 25
Ok, so this is for a floor shift column. It can be a formerly column shifted car, but the outer shifting tube has to be removed for this to work... -
Parking Brake Cable Removal
- dusted72
- Updated
- 1 min read
- Views: 10K
- Reaction score: 6
I just thought this might help some else out. First you have to unhook all the cables under the driver side floor board, then what I did was use...
