You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
The other day I saw a 74 Jensen Interceptor for the first time, they were made in England and very limited production. The only thing I knew about...
-
We've had enough interest in how to leave feedback for buyers and sellers on this site that I shot this video yesterday morning. I hope yall find...
-
Here are a couple of videos showing the method I use to remove and then mount a tire by hand. Always use care when handling tires. It's not...
-
I got new seal and it was good 1/4" smaller than the gas tube and fairly thick rubber. Also awkward to hold tube and press on seal
I went to...
-
I am writing this because I couldn't find any really clear instructions on how to reinstall the windows in my car. I read lots of article's and...
-
Im sure some of you guys know this trick, but I just figured it out today.
Pretty easy to not scratch new paint with this method.
Thread small...
-
This is an A/C electromagnet that strips induced magnetism from ferrous materials. Useful in demagnetizing screwdrivers, wrenches, feeler gauges...
-
Thought I’d do a little thread on how to fix the dreaded factory valve cover wire tabs that frequently break on our 50+ year old Mopars. If you...
-
Hey Folks,
Thought I'd share the following showing our low-buck fix for damaged taillight housings and missing mounting tabs. Being on a tight...
-
I recently disassembled my convertible top pump to inspect its condition. I think most people just replace them when they have issues. It turns...
-
Just thought I'd share a quick tip as I'm doing my wiper seals on one of my Dusters.
-
(Outside) Learn how to get your windshield super clean! The windows of your car or truck are what you look out of and it is important that they...
-
This list was taken from the Classic Industries catalog. It's a good one to save to your Mopar Docs folder :).
Regards,
Mr G.
-
Please keep comments in a separate thread so as not to crowd this one. Thanks.
sireland67 took me up on my offer to rebuild an air ratchet and...
-
Here's a quick thread for the newbies on hose clamps and how to properly install them.
There are two basic types of clamps, constant diameter...
-
I'm so sick of buying those moving dollies and them breaking when I put an engine on them, even the ones rated for 1000 lb. Hell, I could build a...
-
We all know hose clamps are ugly. So with some 1/2 inch heat shrink you can cover them.
To me it's all about the detail.
-
Well I needed to recode a door lock for the passenger & drivers side of the Dart so I took some pics and am doing a mini write up.
I started by...
