Recent content by 67 gt

La 360 stroker solid roller it runs a Hv pump broken in using Joe Gibbs break in after 8k have been using a synthetic with Zinc 15-40 or 20-50 . 75psi cold ,hot idle @850 rpm to provide some oil splash on lifters 35-40 psi 2000rpm and over 65psi . Top end gets fed the via hollow push rod tubes...

I run the tanks inc tank and Walbro pump only noise when priming only !

I got mine from Dan aswell good quality unit same colour coded wiring as Oem ,you will need to source the plug where wires feed through unless you pic the wires out of the old one .I purchased one from classic industries.

Not sure if it’s some one from here who filmed this this is from this event I think . I just watched it on you tube a lot of nice rides and I noticed Keith’s car . He’s the link

And a good solid roller !

Ok try this , take your air cleaner off get someone to operate the key while you look over the throttle body don’t start it just get the pump to prime you should get a prime shot . You will see fuel squirt from 4 injectors not a lot but enough to see if fuel is getting in .It me know before...

I use those and don’t get any droning at all 2 1/2from header collector right through the back . Nice and not loud but when you get on the loud peddle it barks .

Nothing like a sound of a sewing machine. You know they are adjusted correctly. Just a little quieter with a solid roller once warm. Love it.

Oil not blowing out your dip stick tube ? Good easy test to do remove the dip stick get a small balloon and put it over the tube it’s got to fit tight and get the rpm’s up look at the balloon if it starts to inflate it will give you some indication if your building crank case pressure .

Yes

Just had this issue with mine 4 wheel disk crazy hard peddle and it took a lot of effort in pulling it up and got sketchy a few times when some one jumps in front of you than is on the brakes so I ended up getting a few remote boosters done as I needed access up top for rocker adjustments...

It’s a shame all the effort you put into it and parts and he couldn’t be bothered with it anymore I’m glad you bought his stake out and are going to finish it . Will be a nice ride once completed. Good work mate it would have costed him $$$$ if a shop was doing what you provided . Looking...

I like this if the hood is damaged in transport in returning you will not receive credit ! I think they need to practice what they preach !

She he has hair on her shoulders like my Maltese Mate !:wtf: