Recent content by 68gtx

sizes? all the same?

pm sent

can you shoot me a pic?

i am in need of a 7 blade clutch fan18"-19", don't need the clutch , just the fan but will take whatever i can get as long as its straight ..

Got my six pack up and running but have this extra vacuum pot to hook up , I looks like a sort of choke pull offf? But I'm not sure , anyone know if I should just hook it to manifold vacuum?

pm sent

i have a lifter that bleeds down in my 91 roller block after a couple days of sitting , is it ok to replace just the lifters and leave the cam as is ??any special break in requird?

still available?

new holley 850 dp , never bolted to an engine $450.00

new holley 650 hp carb , never bolted to an engine, $500.00

most cfm calculators call for less than a 650 cfm though.. which is a little misleading as most say a 750 will work well

looking for a new carb for my project, mild 360, edelbrock heads, performer rpm, intake and heads, 10:5 to 1 comp. roller cam, headers, 3000stall, and 4:10 rear gears, if needed I can get cam specs, street car, occasional street legal night at the strip, I think I want a mech secondary, thinking...

pm sent

pm sent

bingo!!!!!!!! exactly what it was.. outer seal lip had somehow folded over and was creating little rubber shavings like the inside of a tire after you run it flat.. popped in a new seal, noise is gone, well now my p/s pump whines when it is hot but that's an easy fix... thanks for everyones input!