How about adding a third header to the poll? Heddman 75109/75110. I got a set of Harold's headers but am reconsidering as I'm now planning on a stroker and need the breathing room. Heddman's look to fit the bill with 1 &3/4 or 1&7/8" primaries and a 3" collector versus the 2&1/2" collector on...
I called Dick Landy a couple of weeks ago looking for a small blower setup only to find out that the business got sold shortly after Mr Landy passed away and that the new owners are no longer in the MOPAR business. Seems like DL now focuses on the VW market only. The lady I spoke with took...
Not Barracuda but early A below.
http://www.bigblockdart.com/index.php/topic,16744.0.html
http://www.angelfire.com/mo2/radrodder/66WheelWells_Tub.html
I've looked pretty hard at doing it on my '64 but am concerned about two aspects. 1. I don't want to section or toss the rear seat and 2...
Deep into winter in Fort Worth which is soon to be in my rearview mirror as I move back to sunny San Diego in a couple of weeks! Hopefully there's still some of that NW swell in the water for a little while.
-BirdRockBomb
Thanks Jim. I sent a request to post a classified ad to "The Mopar Club San Diego" as well. I've also asked them to mention it at their next meeting as well.
Mark
West Coast FABOs,
I'm about to commence a move from N. Texas to San Diego courtesy of the USMC and need some help. I'll be arriving in San Diego for a few short days during the week of 18 January and then spending the next few months ('till June) in North Carolina in training.
I have an inop...
Ordered mine in July, got them yesterday: 30 December. Had to hound him pretty hard over the phone and got many promises of "next week" since September.
Headers received from Harold yesterday. Look pretty good. Advice offered to those of you who are planning on going this route: DO NOT send him money up front; go COD. From what I've read, the COD orders get delivered much quicker than those that are paid in advance. That being said, they...
Probably against the rules to make a post blatantly endorsing a specific manufacturer but check out Strange's axles. Competitively priced, I just got a set of their 30 spline street axles for my 8 & 3/4. I previously had a set of their race axles in a 9" behind a 3300 lb manual tranny 10.90...
Off the rotisserie and turned into a roller for the impending move from Fort Worth to San Diego. Bunch of quick work on short notice only to be blown apart again after the move. Ah, the trials of life in the USMC!
Work done to date:
-media blasted top and bottom
-frame tied
-primed in epoxy...
Wedgie,
Have thought about calling the BBB and the Chamber of Commerce as well but have held off to date. I'd read about similar challenges dealing with Harold in the past but thought that he had changed his practices. Unfortunately I did not heed the warnings and sent him money up front. I'm...