Recent content by DartIan

I'll be the first to say it. Snap On. Buy it once don't have to buy another another. If you brought your car in for service at a dealer. Would you want them to torque your lug nuts with a snap on or a harbor freight? I know my answer. Especially if it comes down to safety of me and others on...

Drain it and put DOT 4 in it. The solution itself is different and it will resist to higher heat temperatures and moisture absorbency designed for the OEM brake system. better to be safe than to have your fluid start boiling and bubbling causing spongey brakes while you're on a drive.

Snow makes it fun whatchu talking about

i Pm'd you a week ago i believe ill do it again.

Thank you. Beat me to it. I have a pit and she's a princess. Prayers for dodger.

No worries!

You would have to cut the housing and axles down to the factory or desired length. Grind off and move the spring perches in. Then grind off the shock absorber mounts. Then it would go in. But these axles are 8 lug. So you'd need a body axles for the Dana and new axle assembly's because this axle...

400$

Found this on Instagram. I don't think I'm crazy about this one.

Anyone?

450$

Hey And here are the pictures i promised.

Yes it's an off centered pumpkin. Also would need new axles for it has 8lugs on it now.

Hey all, Here is a Dana 60 out of a dodge 3500 van. The van had 60,000 miles on it when I pulled it two days ago. Has the ABS plugs on it. New shock absorber on it and it was well greased and taken care of. 500$ takes it. Please come pick it up located in Hanover Massachusetts...

No I don't have a compression tool I need to buy one and ill report back when I can. I'm just afraid it'll come to me buying a whole new set up.