Recent content by eestatic

Hi halifaxhops! Do you still have the A.M. radio, knobs & bezal? If so, how much to ship to 78956? Thanks Dennis

Ethel checked into a motel on her 65th birthday, lonely, a little depressed at her advancing age, so she decided to risk an adventure. She thought, "I'll call one of those men you see advertised in phone books for escorts and sensual massages." She looked through the phone book, found a...

Thanks for reply! My concern is was when I searched for the "slip yoke #2-3-800kx" the closest number I come up with is [ 2-3-8001kx ]

Greetings FABO! Finally getting around to upgrading my drive line & rear end change on my 65 Barracuda w/904. I noticed that on various forums the parts listing for the upgrade have a "Slip yoke 2-3-800kx" listed as one part needed but searching only shows a "2-3-8001kx". Can anybody clarify...

Thanks for the input! I'm leaning towards just replacing w/stock stamped steel...[kiss method] specially after thinking about the stresses from rocker arms bending push rods.

Considering the possible wear in old stamped steel & upgrade w/similiar replacement vs reuse of adjustables + purchase of appropriate lenght push rods. Pros Cons

Hi FABO! I'm getting a single ticking in my valve train since my 318 rebuild. I re-used the stock stamped rocker arms w/new push rods with the comp 268 Hyd. cam. The Stock engine at some point probably was sittin' for a while..[valves stuck?]...some of the push rods were sorta "Z" shaped/bent...

"Speed ratings are based on laboratory tests where the tire is pressed against a large diameter metal drum to reflect its appropriate load, and run at ever increasing speeds (in 6.2 mph steps in 10 minute increments) until the tire's required speed has been met" What happens and for how long...

iirc....[read somewhere] that the speed rating was for period of one hour @ max speed..

I call that music!

Yes, i also milled mine <both> sides .250 to assisit in clearing the passenger fender. In addition to a smaller coupler i cut my column tube back for clearance plus installed a bearing at the tube's end. And in paranoid mode, put a shim under driver side motor mount. Fan is still centered in...

I used the Dakota mani's on my 65 Barracuda. I have manual steering, console shift. Search my postings.

I have a '74 Dart 4 dr. , are they the same? I can get pics if interested. I'll look closer at condition.

My wife was standing nude, looking in the bedroom mirror. She was not happy with what she saw and said to me, "I feel horrible; I look old, fat and ugly. I really need you to pay me a complement.' I replied, "Your eyesight's damn near perfect." And then the fight started........

I believe rubber...I acquired the parts a few years ago..[memory]..they are black in color if that makes any difference. I'll see if i can find the receipt.