Recent content by littlestroke

Anyone running a Mallory Hyfire VI multi-strike system? I was looking at one and I just wanted to get the ups and downs with this system. How does it compare to MSD? The one I looked at, had a 2 step , retard, and a built-in window switch.

Here's my combo: This is a race only combo. .030 360 190kb's 10.8 comp 587 heads with port work 2.05 1.62's roller rockers 1.5 holley strip intake proform 750carb Racerbrown st-21 520lift [email protected] 13/4 headers 4400 convertor CRT 727 4.86 gear 29.5x9.0 mt's MSD elec system 38...

Holley strip-vs-M1mopar-Victor340.Has anyone compared these single intakes for the best performance?

I need two tenths out of this combo. Were is the best place to start? Right now, NOS is not a option. Here's my combo: .030 360 190kb's 10.8 comp 587 heads with port work 2.05 1.62's roller rockers 1.5 holley strip intake proform 750carb Racerbrown st-21 520lift [email protected] 13/4...

I wanted to try something different, and I need some help. I want to put the 73 cuda's hockey stick decal on the side of my 70 dart. Will it fit? Or dose it sound like a bad idea. I can always go back to the bumble bee. Thanks for any help

I wanted to try something different, and I need some help. I want to put the 73 cuda's hockey stick decal on the side of my 70 dart. Will it fit? Or dose it sound like a bad idea. I can always go back to the bumble bee. Thanks for any help

I want to run a transbrake in heads-up racing and I have been told the PG holds up better. If it's cheaper to go with the 727 I would, but I'm really looking for something that will hold up. By the time I get a brake and alum drum for the 727 I will be looking at 1500 with labor. If it breaks...

Who's running a power glide behind a small block? Who has the best adapt kit? Will I need to relocate the trans mount location or shorten my driveshaft. How about the convertor and starter. What will be my total cost at least a ball park figure.Thanks for any help.

Who's running a power glide behind a small block? Who has the best adapt kit? Will I need to relocate the trans mount location or shorten my driveshaft. How about the convertor and starter. What will be my total cost at least a ball park figure.Thanks for any help.

Anyone using the weiand X-cell intake on a 360? If so what is your combo and how does it compare to other intakes. I would like to replace my holley strip intake with one and I needed some imput. Thanks

Anyone using the Hooker ceramic coated headers? I'm trying to get a set and I wanted to know if their coating,is done on the inside and outside. Does it peel after sometime? I can get them done locally by a pretty good guy for the same money, but if I could buy them ready to go that's fine also...

I'm trying to pick-up a little ET with my combo and I have a choice of the Hooker comp 1 3/4 or the Headman hustler 1 7/8. Which is best with my combo. I'm going to run 1/4 and 1/8th mile this year. I'm currently using the dynomax street header. Here's my combo: .030 360 190kb's 10.8 comp 587...