Recent content by MagicMan

Different wires, I never could get mine to look right so I went with a make your own kit from MSD. Came with lengths of wire, several different ends, and a tool for crimping them on.

Is that the same part I posted from summit

Has anyone removed the heater box entirely and replaced it with a simple universal hot rod heater ? I have a factory AC car that I plan on never fixing the AC. Now the heater core is leaking as well. I was thinking something like this just to knock the chill off and defrost the windows...

Nothing that hasn't been done before, but it's mine. 1969 dart OEM mustang 17x8 bullets all around. Front: 235's would like to go up to 255's soon. Lowered with 1.14 bars Stock 69 Lowers 73 uppers and knuckles Córdoba 11.75 brakes 3/8 spacer to clear hub and tie rod end. 3" studs with open...

Just drive it, make it mechanically sound and enjoy the car for what it is.

Looking for a 4brl Intake for my 69 model 273, would prefer a small port performer or something similar but am open to about anything budget minded. I would even take a factory cast intake providing the price is reasonable and shipping wouldn't kill me to 45701. Thanks Folks

@318willrun , you said earlier that the summit k50052 cam wasn't your first choice but it fit the budget. What other cams would you have liked to use in this build ?

I have an Edelbrock Streemaster 318 intake, it's a small plenum single plane intake that's supposed to make good tourque. But I've read a lot of guys that say it falls on its face at 4500rpm.

Is the street dominator large or small port ?

Stock Compression so advertised 9.0 to 1 ? As far as a I know non adjustable rockers so hydraulic, stock converter.

Hey Folks, finally got my ride on the road and would like to add a little extra grunt. Unlike most I am not looking for quarter mile full throttle acceleration. My car is built to handle and I'm looking for a strong mid to mid upper range cam to pull through the corners. A soft bottom end isn't...

Hahahaha, that's awesome !

I don't have all of it, a few pieces that are pretty bent up beyond use but I'm sure replacements could be found.

Howdy Fellas, Finishing up the details on my budget beater daily banger. Some yahoo before me pulled all the trim off except the rear doors. Now I'm at the point of trying to decide if I pull the rear door piece off and fill the holes or put the rest back on. I like the clean look, but also...

Has anybody parted a 69 4dr custom that still has the side trim ? Not looking for show quality but good driver quality. Let me know what you have and how much. Thanks.