My work truck started cutting out and almost back firing every time you floor it or accelerate fast.bi bypassed the ballast with a wire and the problem goes away. Bought a new ballast but no change. It acts like a lean out problem. Is not a carb problem. And like I saidbit doesn't do it when I...
I know its not an A-body but i need yalls advice. I might be trading for a 71 satellite wagon. It has a 318 4v and duel flow master exhaust. Solid body. Okay interior. Runs good. I have no clue on the value of these and was hoping you could help me out. Just want to make sure if I do it and...
Ok, well I will look into the aluminum route. I might stick with the factory block for this one tho. Have to see what the budget will slow, since the aluminum block will add about another $6,000 to the budget that wasn't figured in. Which for me is a good amount more. Thanks everyone for the info
I'm looking for a rolling tube chassis car or a back halved car. Finished or unfinished is fine. Looking for smaller and lighter cars/trucks but will consider others. Let me know what you have. Title is preferred, but not deal breaker. If a good deal I will buy with a bill of sale. So let's see...
A honest guess would be stock specs. I mean they could be more but would have to have the pressures checked. So for scenario perpose I would say stock. I did notice that the spring pads seemed to be machined to except larger than stock diameter springs. But I never measured them so its just a...
I have a pair of new complete ready to bolt on magnum heads. I bought them for a project a few years ago and have no plans for them now. I'm building a bb and want to just sell these to put more cash towards the build. They are aftermarket castings. 1.92/1.60 valves. Heads look nice. Would...
I'm trying to put up a for sale add but I can't figure out how to upload my photos from my phone. I clicked on the attachment tab and it brought up the upload screen but I don't know where to go from there!! Please help!
Who sells the Siamese bore cast iron bb blocks?
Any cons on these blocks?
What HP levels will they hold?
Are the finish bores precisely machined or should I get a rough bore then have it finished?
I'm deciding if I want to just go this route instead of a factory block and I could go with a...