Search results for query: *

Hello everyone, I was wondering if anyone knows or has bought anything from demon joe. I bought some wheels about a month an a half ago and never received them. I have sent him numerous PM's and he replied a couple of weeks ago saying he was out of town and he was going to mail them out. Well...

So I have to change the torsion bars out in my Dart. I looked online and I was looking at the .92 bars from PST or the Mopar Performance .92 bars from Summit. My question is either any better then the other. I ask because the ones from Summit are about $80 cheaper with free shipping then the...

I am looking at going to efi on my Dart. Was checking out the FAST EFI 30227 kit or the Holley Avenger EFI 550-401. Any advice would be appreciative.

I am running 155/80 15's on the front the problem I am having is the front tires are wearing very badly in the inside. The first problem was that it had drag shocks on the front and the alignment guy couldn't get the front end to set at the same height. So after I replaced the drag shocks with...

Just looking at getting a new torque converter for my truck and was looking at the tow series from Hughes. Has anyone used Hughes torque converters and are they good.

I am running a single plane air gap holley intake on my car right now but I would like too run a dual plane intake for more low end grunt. I would like some opinions on which would be the best to use. It is a 360 bored .060", about 9.5:1 comp., Purpleshaft cam (.484" lift), heads reworked with...

I have been driving my car for a couple weeks now since I got it done. Seem to be running just fine until a couple of days ago. It usually ran about 200 now it seems to be running at 220. I checked the engine at the water neck with a temp gun and it was reading 220 and then I checked the top of...

Does anyone know what the correct travel the slip yolk should have on the driveshaft.

Anyone have experience setting up a Mech. Adv. MSD distributor. I have a warmed over 360 in my dart with a Purple Shaft 484 lift cam. I am running an automatic tranny with a 2500 stall. The MSD kit gives you about 6 different options on how to set the advance. I am not a wizz on timing advance...

I have a 360 backed up by a 727 with a 2800 stall in it. I have had two issues with the transmission. First when it shifts from 2nd to drive it acts like it shifts to neutral for a second then goes into drive. Then second problem just started happening. I put about 80 miles on the car...

Hi I am wondering if anyone has installed the lokar kickdown linkage on a small block 727. I have the throttle and kickdown linkage installed on my dart and i am having a hell of a time getting the adjustment right. thanks