Search results for query: *

Thanks for the tip, took my passenger side one and set it in the driver side I see what the modification would be! Thanks

Anyone have a 1963 valiant driver side tail light lense?

Did I post in the wrong place?

I'm looking for parts for new project: 63 valiant tail lights 4 barrel intake for a slant six header for a slant six Thanks

I bought this air dam 10 years ago on ebay for $75, the ad said it was for a 73 to 76 duster/dart but from the shape of it I thought it would work on my 72 duster. I did have to recess the center of the air dam to clear my license plate bump on the bumper but it turned out pretty nice I think. I...

My son raced sprint cars, I asked him what paint they used on their headers, he said wd40! Keep them wiped down they won't rust and stay reasonably black, Thought that was interesting!

Just shaved head and a cam. Building a new monster 10.5 to 1 compression slant 6 engine though!

I bought my headers new, and out of the box, I had my headers sand blasted, then had them glass beaded to clean up any misses the sand blaster missed, then wiped them down to grease and wax remover then painted them with high temp paint. It's been 3 years and maybe 3000 miles and they still...

Could've been the difference in motor mounts?

No mods, I had a set of short tube(lots of clearance) and a set of long tube (about 2 inches longer), I used the long tube set, they are probably about a 1/4 inch away from the steering box!

'72 Gold Duster

I took out the LED's and put regular bulbs back in and now everything works perfect, my turn and emergency flashers were both bad, I assume voltage difference between low voltage LED bulbs and higher voltage flashers maybe didn't agree with each other, none the less I'm moparing happy again...

I'll work on that in the morning, thanks!

So if there are led lights in the rear they are not creating enough current?

Yes both directions, turn signal on all lights light up front rear dash indicator, they just dont flash

Brake lights work

If I turn my turn signal on the lights will come on but not flash, I thought maybe flasher was bad so I installed a new one and it still does the same thing. Four ways do the same, light up but not flash. Any ideas?

Thanks

Well that would be correct, because it is a slant six!

That's the problem, there is no way to adjust the free play because everything is adjusted as far out as possible!

Top picture the pressure plate is unbolted from flywheel, bottom picture it is bolted to the flywheel, my question is should the fingers drop that much? With it in the car like that the adjusting rod is fully adjusted to the end of the rod, and the clutch engages right off the floor! Grease is...

Thank you!

Anyone know the size of the centering pin for the shifter box, for adjusting the linkage rods?

904

I am putting a 75 V8 motor an auto into a 72 dart, the rod that goes from the column to what I call the shifter bell crank, is to long I think? Are the rods from a S/6 to a V8 different?

Anyone know where I can get shifter boot for b-body bench seat car with a pistol grip shifter? The last two I got from brewers performance and they were terrible, they both ripped after several car shows, literally a couple hundred miles! Part #SB755

Ok thanks for the info!

Its for sale locally, if it's not anything performance wise I'm not going to buy it!

I do know the head was used from 1964 to 1966 according to the casting head casting number.