Search results for query: *

I have a 440 edelbrock performer intake manifold on my build street build with holley sniper efi is the performer fine or should I step it up to the rpm intake manifold

Looking at my 440 motor and noticed. Casting around lifter looks like it chipped away has anyone seen this also is ok ?

What can I fill the dimples on my 440 pan with so I can use a mr gasket windage tray with rubber gasket ?

Purchased a holley sniper will be installing in a month or two if you have any advice let me know intank fuel pump ? Or inline

When is it necessary to install arp studs in the 440 lower end mains building mild street 440 will stock bolts hold up ?

Looking for pushrods for my 440 build need to be 9.150 long ball to ball I've found tons of oiling push rods but none non oiling I can see my luniti lifters have oil hole but I know mapar uses the shaft mount system for oiling will I see any issues if I get oiling pushrods is my question

What is suggested for the 500 hp range for oil pumps is the standard melling oil pump fine or do I need a high volume I have a 440 with a hemi 6qt pan

Looking for mopar drive shaft 45 5/8 center to center 7290 u joint or 7260 let me know what you have

Looking for stainless roller rockers was looking into prw but than saw speed master for alot cheaper but they look the same anyone use either of these ?

I have a 440 I'm installing e street heads on 75cc chambers was wondering if I can use the smaller .20 steel shim gaskets on aluminum

I have a 440 I'm installing e street heads on 75cc chambers was wondering if I could use the smaller .20 shim gaskets on aluminum heads ?