Search results for query: *

What is the proper torque? I know I read on here somewhere that the listed torque value in the manual was wrong-too high. Thanks.

How do I accomplish this feat? Will drain radiator part way down but plug in side of block is frozen. How do I keep coolant from getting into the valley and into the oil? Still have almost fresh break in oil and need to keep it clean. Thanks for any tips.

I have a rebuilt 318 with small summit cam and hydraulic flat lifters. Engine sat for over a year before break in oil was added, oil pump primed and started. Engine started right up. Engine has only run about 30 minutes for camshaft break in and a few trips around the block. Lifters quieted some...

I attempted to install the oil pump drive gear and it is stuck too far up. This is a rebuilt engine I purchased without the drive gear installed. It is a 318 and has a new high volume pump. I purchased the heavy duty drive gear from mopar performance. Primed the oil pump with a long hex rod tool...

I have a 67 Dart that was a 273 2 barrel car from the factory. I put in a 318 with 360 heads and factory 360 4 barrel manifold. I bought an aftermarket replacement 340 throttle cable holder (bracket) and installed it. I bought an aftermarket replacement 340 throttle cable and it is several...

I have a 318 with 360 smog intake and heads. EGR valve holes on top of left side intake have been covered with a plate. The EGR holes in the heads by the exhaust manifolds have been plugged. That leaves the 2 holes in the floor of the intake below where the carb sits. Is it necessary to plug...

Do I need to plug these holes to use on a non EGR LA 318? One is threaded but one is not. If so, how do you plug the hole that is not threaded?

Do I need to plug these holes to use on a non EGR LA 318 ? One is threaded but one is not. If so, how do you plug the hole that is not threaded?

What goes over this opening? This is the drivers side of an LA 360 intake with 360 heads on a 318 block replacing a 67 273. Have no idea what this is or what to do with it. Do I need some kind of block off plate?

Trying to find out if the spool mount bracket ears mount behind the ears on the block on both left and right sides. I assume left side shown below is correct? If so, does right side mount same way? Thanks.

On my 318 I have the 2 engine dowel pins that align into the corresponding transmission bell housing holes. One protrudes 3/8 inch from the back of the block while the other only does maybe 3/16 inch. Is this enough or do I need to keep trying to punch it through? I soaked it with wd40 and took...

Where do I find a correct oil dipstick tube for my 67 318 block? Tried to reuse the old one but can't remove it without mangling it. Have heard the chrome ones don't fit well. Also, my original tube was angled out toward the front of the block but all the new ones I see are straight. Was mine...

Is it the exhaust manifold studs on each end of the smallblock head that go into the water jacket? Do any of the bolts? Thanks.

What are the threaded holes for below the exhaust ports on these LA 360 heads? Far as I can tell they don't go into the water jacket. I have 318 exhaust manifolds that leave these holes uncovered. Thanks for any info.