Search results for query: *

Hey guys, question about the celebrity caliper install on Scarebird style brackets. I understand that the calipers are single piston and therefore need to slide, but if I torque the caliper bolts to spec on the brackets I don't understand how I will get any movement. The metal sleeve that the...

Did the preliminary search and came back with info on their disc conversions but couldn't find anything on lines. Getting ready to order all new lines both brake and fuel for the Barracuda and am leaning toward right stuff as shipping is free. Anyone have experience with them. I realize most...

Car is a 68 Barracuda with a factory sway bar. Getting ready to go through the front end so I may as well go BBP Disc up front. Will the swap interfere with the factory sway bar? I know it can interfere with some aftermarket. Just wanting to know before I go to the yard and gather parts. Thanks

Does a mopar aluminum master cylinder off of a 88 Van have one for the drum side? If I pull the brass fitting to remove a check valve using a deck screw like theramman can I reuse the fitting? Just wanting to know before I go and try to pull it out Thanks

I know there are differences other then the reservoir size, but will it cause an issue if I use the aluminum MC off of a Dodge Van on an all drum setup? I am going to 4 wheel disc with time, but I was able to acquire the MC and the one I currently have on my car is rusted cast iron. If If I can...

Recall reading somewhere that this swap will not work, but can't seem to find that info anymore. I ask because I have access to a very cheap front disc setup (complete) off of an Aspen and have been on the hunt for a disc setup for my dart.

First time having an early a as opposed to a post 67 car. I upgraded the brakes and everything is working ok. But my question is if the rear bowl on the mc should feed the front or rear brakes. If I remember correctly it should feed the fronts but I need conformation. Thanks

I recently ran new lines through my whole car and upgraded from single to dual master cylinder. I've bleed all the brakes and the master but its still really spongy. Do I need a longer pushrod? Car is a 65 dart and I put a new master cylinder for a 68 dart in it. Thanks

Does anyone have a template of some sort they can email me? My old lines are too trashed to use and I figured I'd ask you guys before I take the time to measure it all out. Thanks

I am finishing up my brake upgrade from a single to a dual master cylinder. I am currently bending all new lines since the old lines were original from 65. My question is I am using 3/16" line all around as was factory, but the line that was running from MC to distribution block was 1/4". Should...

I was wondering if anyone could shed some knowledge on me. I am re-doing the brake lines, and putting new shoes on my car. I figure since I am doing this anyway I might as well upgrade to a dual reservoir master cylinder as well. My questions are as follows: 1: Is this bolt right up or will I...