Search results for query: *

Ouickie question .. How much HP/Torque can a stock 8 3/4" axle take? Thinking of going Yukon/Strange/Moser with out the green bearings. What's the best axle for the value? The Yukon's?

Does anyone have a Duster/Demon/Dart with a 8 or 10 point cage and subframe connectors in it? I'm just curious (and may pick your brain for information) I havent seen many... I'm gonna run a 360 (hoping 400hp) / 727rev pattern / 8 3/4 (4.11's) Surely more people than I have this combo than I...

I'm installing a 10pt cage into the 73 Duster and got the outriggers and main hoop tacked in place. The question(s) is.... How far back should I attach the rear legs? Should, I put them to the top of the frame rail, over the rear axle OR further back? The reason I ask is because the kit i have...

Hi Guys!, I just got my new 10 Pt. cage from Chassis Engineering today for my 73' Duster. Still sorting out all the tubes <geez> I was wondering if any of you could provide a few pics for what you did to attach the 6"x6" plate to the floor areas? The plate is flat, the floor is not...lol What's...

Looking to get my 10pt cage this week from Chassis Engineering. Was wondering if anyone has installed one from from them? Do I want the 1 5/8" or 1 3/4 " (I assume the 1 3/4") The price is real close. I'll be using the mild steel. How about some generic, this part goes 1st instructions? 1st Time...

I spent today installing sub frame connectors on my 73' Duster. I have the bolt in ones from Chassis Engineering. I just wanted to say what a pain in the #@!&^!!@#@ Job even with the car being a Shell. The brand new 1/2 cobalt drill bit would constantly get hung up when drilling after 95% the...

Is there any easier way besides welding a washer n basically Yanking it out? with a slide hammer? And how do you get the pivot shaft out? Any Special tools out there to make the job easier? I'm a sucker for specialized tools even if I only use em once or twice. Get it done right. :-)

Hi, I have a 73' Duster that is ready for a New roll cage, I have the bolt-on subframe connectors and plan on welding them in. I was wondering if anyone could tell me ...How many point cage should I use for like a 500 HP car? It will be a street/strip 360, Manual reverse pattern 727 trans. 8...