Search results for query: *

Hey everyone, frustrating afternoon. Finally got enough free time to try and mate the 727 to the 440, and it didn't fit. The Bell Housing stands off about 1/2 - 3/4" from the engine. The Bolt holes line up perfectly, and the Converter is inserted all the way into the Trans input shaft, but...

I need your help guys, I haven't mated the transmission to the motor yet, but was curious if the original Transmission Cross Member (originally a Slant 6 & 904 Tranny) will bolt up to the 727? I've read that they both used the same cross member, but figured I'd ask before I start dropping this...

Will a tranny pulled from a 68' 225 Dart bolt to a 69' casting 440 Engine?

I'm trying to weld my Axle Tubes, and yes I'm trying to pinch pennies where I can to help save for that "GAS" that the Dart will eventually be sucking down. Is there a way to get the tubes aligned for welding without spending a small fortune on a Jig? One idea I had was to a length of...

Anyone know the axle tube diameter for 8 3/4 Rear? Trying to find mounting plates that will accommodate a 3.25" axle tube. So don't know if the 8 3/4 will do, or if I need plates for a Dana 60. Thanks

Will a Slant 6 904 Transmission bolt up to a 440 Big Block? I already have a 727 Transmission freshly rebuilt, but am thinking that maybe the 904 may also be an option. Thanks...

Interesting situation, I'm pulling the 904, and dropping a 727 Trans in, and this will drive the Ford Posi 8.8 Rear. Is anyone running a similar setup? I'm trying to figure out the drive shaft lenght, so I can have the current shaft shortened. Any tips or recommendations on how to measure...

I'm getting ready to drop a 440 into my 68' Dart and was wondering if you might have any recommendations on Oil Pans. She currently has a Slant 6 and 904 Tranny. I'm getting ready to drop a 440 .30 over, and a beefed 727 in. I'm planning on using the existint K Member and Schmauker Mounts to...

First, thanks to everyone who contributed to my postings and helping this fledging Mopar newbie :). It's been quite a learning experience, but finally see some light at the end of the tunnel. The Dart is coming together, and the final piece will be the Rear end. Thanks to the many responses...

Hi Guys, I may be in a position where I need to have a Ford 8.8 Rear shortened. First, I haven't a clue where to go in the Philadelphia area that handle a job like this, and also how much would be a reasonable budget to set aside for the job. I'm at a point where I have to decide do I...

Hey Everyone, Ok, got the engine and tranny squared, now need to focus finding a 8 3/4 Rear. I'm going to local salvage yard tomorrow, and wanted some advice on what would be the closest match. How much modification does a B Body rear take to fit into an A Body? Also, how do Dodge Truck...

Can anyone tell me how I can identify the Rear Dif in my 68' Dart. I've attached a couple of photos, but don't know if they will help any. Thanks... Pat