Search results for query: *

What would be the torque for the 727 tranny pan with a 3/16" reusable gasket.. Heard anywhere from 7ft lbs to 12 ft lbs.. Thanks

Ok guys Question: I have to replace both inner and Outer tie rods on the passenger side on my 340 and would like to know if both are right hand threads or is the inner tie rod left hand and the outter tie rod right hand threads or visa versa. The person at Auto Zone was confused when looking...

Question for anyone who can give me a good answer. I have a 750 Edelbrock on my 340 and it has been giving me problems lately where I cannot get it to idle consistantly. It sounds as if it is sucking air. Under acceleration the car runs great. Changed everything that has to do with vacuum ...

So I would like some opinons. I am tossing it around about turning my car onto the Blue Bottle and my question is do you think it would be worth while ? Currently running a .508 purple cam with 3500 Stall convertor and I have a 9" Ford rear end with a 3.89 gear set, dyno at close to 413 hp. My...

I am running a Holley electric blue pump and I recently was experiencing fuel problems in which I think I have solved it but I do have a question. When trouble shooting my fuel pump I noticed that it was warm, not on the area where the lines enter and exit but the body where all the enternal...

Hey guys I have a quick question; I am replacing all my valve springs and my flat tappet hyd shaft mounted rocker arms. I noticed that there are two rocker arm ratio's one a 1.5 and a 1.6 What do they mean by this? My engine is a 71 340 with .509 purple cam Thanx

Hey guys, I have a quickie question, Today my intake valve spring, in my 340, for my # 7 cylinder collapsed and is now in pieces so my question is can this spring be replaced without tearing off the head? With todays technology I was thinking that their is a way but if I have to tear it down...

Hey guys I have a question, I have a 509 mopar purple cam with flat tappett hyd lifters in my 340 and would like to know what the rocker arm bar torque setting would be ? I believe it is around 17.5 ft/lbs. for stock bar so would the torque setting still be the same using the 509 cam? Thanx

Ok guys I am thinking about swapping out my chain timing gear set to a Mildon gear Drive. I know they have a quiet and a noisey type which is the way I am leaning. My buddy has one in his ride and I love the way it sounds, almost like its supercharged... What cha all think?

Hey guys I have a question. Yesterday I went out and started my 340 up and noticed that I have a noisey lifter and I mean Noisey but once the car idled for about 3-5 minutes it quieted down. The last couple times it did the same thing so I am thinking that I may have a weak lifter. I live in...

My Rear main seal has begun to leak oil in my 340 not leaking much but a nusiance. I put a quart of Bars leak rear main seal stop leak in and its still dripping oil. A lot of people told me they swear by this as it has worked for them. My question is how much of a job is it to replace this seal...