318 build

[Vikingpolarbear]

I'm building a 318 for my '72 demon and I'm getting a cam that runs at 2600-6000 rpm and was wondering if anyone had any suggestions on what springs, valves, and intake to use. It'll be a daily street car that needs to be able to perform too, also what would be good rearend to run. Thanks.

 

[rumblefish360]

The cam you choose comes from a manufacture that almost always has a recommended spring to use that they sell. Considering the power band of the cam, in guessing your not going to cool around to much with a hot street car and so I would recommend a 2.02 valve and a RPM intake manifold. Rear end wise, a 8-3/4 is hard to beat.