[FOR SALE] 67/68/69 FB Barracuda body/Parts

-
Status
Not open for further replies.
Treblig

Treblig

Well-Known Member
Joined
Oct 5, 2013
Messages
8,442
Reaction score
6,750
Location
South Texas
Rating - 100%
12   0   0
Contact seller
From Corpus Christi, Texas I have one 67/68/69 Barracuda body with a few other parts. If you see it in the pics then it's for sale. I am willing to chop this body into enough pieces to sell it all and ship by bus in most cases. The front end, fenders and frame rails are sold and delivered. Trans mount and floor are sold and delivered. Steering column is sold as well as console and AC/heater. Dash has been cut around radio area. But all the rest of the body is there and in pretty good shape. We had no need for salt on our roads in South Texas so this car doesn't have the usual rust. The paint job on the car is over 8 years old and it has been sitting outside for all that time and you can't hardly see any rust at all.

Doors - $80 stripped clean (cheaper to ship that way)
Rear window trim - $250 (pretty nice with a few small dings and scratches)
trunk lid - $100 pretty sure it's a 68 because it had the upper and lower trim on it. Trim is bad. Also trunk has had some repairs in the grey paint area in pics but the important pinch weld area (bottom rear) below the lock has no rust!!!
roof - very nice $150
Pillars - nice $75 each
rockers - very little rust $75 each
quarters - $125 each, some small repair areas but very fixable
roof to quarter transition (rear) - $60 each
trunk pan complete - minor surface rust $125 (cut to your specs)
Rear valance - $125
tail light area - $50 each
rear rails - $100 pair
7 1/4 rear - $75
trunk hinges w/springs - $75 pair
hood - $100
Anything else just ask
ALL PARTS PRICES ARE PLUS SHIPPING!!

Or you can have the whole thing (minus the rear window trim and rear glass) for $650!!! PLUS SHIPPING
Many more pics available. REASONABLE OFFERs ENTERTAINED!!!
Treblig
 

Attachments

MOre pics...

Treblig
 

Attachments

Still have many body parts, rear 1/4s and trunk pan are sold!!!
 

Attachments

These pics are being posted for 69fastbackfish:
The holes in the front of the windows are for the hard felt guides. They are pressed or attached to the window using the holes at the top and bottom. It makes it difficult to remove the window from the vent channel because you can't just pull it out of the channel, you have to slide it out the end very carefully or you break off the felt runners. If your glass is missing these I have no idea where you get new ones, they seem to be permanently attached. As you can see, this driver's glass is missing one although it's probably in the bottom of the door and could be siliconed back in place. Without these felt runners the glass would probably not slide up and down correctly. There's also a thin hard plastic film attached to the felt runners as you can see in the pic. The hard plastic probably helps the window slide easier and with less friction. Hope this helps.

treblig
 

Attachments

More pics as the Barracuda disappears before you very eyes.........

Passenger tail light bucket sold, hood hinges sold, driver's regulator sold, driver's b-pillar sold, rear quarters sold, trunk pan sold, trunk lid sold. Some of these are pending payment.

Treblig
 

Attachments

sleepyhead416 said:
jack mounting brackets & hook
Click to expand...

Let me check on that. The mounting brackets are attached to the part of the 1/4 panel I removed and sold but I still haven't shipped the 1/4s yet and the person who bought the 1/4s doesn't need the jack mounts (I don't think). I also think I have the hook?? Will get back to you next week.
Thanks,
Treblig
 
Member who had said he wanted the trunk lid just backed out for lack of funds. So the lid is up for sale again.
trunk lid - $100 pretty sure it's a 68 because it had the upper and lower trim on it. Trim is bad. Also trunk has had some repairs in the grey paint area in pics but the important pinch weld area (bottom rear) below the lock has no rust!!!

treblig
 

Attachments

67cudafb said:
Hey Gil received part and left you a positive feedback. Thanks Bill
Click to expand...

Thanks "67cudafb". I have sold many, many items with only one complaint. The one complaint I immediately returned the guys money and paid for shipping back to me and sold the item to someone else. But no one has left feedback except you, although I have had many PMs thanking me and saying that they were happy with the parts they bought.

Thanks,

Gil
 
Status
Not open for further replies.
-

Similar threads

Baron007
  • Locked
[FOR SALE] Parting out 69 Dart 4 door (Belgium, Europe)
Replies
9
Views
791
Baron007
Baron007
G
  • Locked
[FOR SALE] 1967 barracuda parts
Replies
0
Views
429
Grumpyb
G
jagsdtc
[FOR SALE] 67 68 69 Barracuda rear bumper mounts, Bumper cores
Replies
0
Views
138
jagsdtc
jagsdtc
rlcbit
[FOR SALE] 67-69 A body 383 left side engine mounting bracket & Insulator
Replies
0
Views
112
rlcbit
rlcbit
jagsdtc
[FOR SALE] Bumper Cores 67 68 69 Barracuda
Replies
0
Views
68
jagsdtc
jagsdtc
Back
Top Bottom