Bucket seat hole meas. needed! help

[swing69]

Hi, I marked out where I think the bucket seat holes should be according to the "dimples" in the floor for my 73 Dart sport (bench to bucket conversion).

Can someone with a bucket seat car (with the buckets removed) fill in the blanks for me?

A) On the drivers seat, the front to back hole spacing is ________ ".
B) On the drivers seat, the right to left track hole spacing is _______".
C) On the passenger seat, the front to back hole spacing is _________".
D) On the passenger seat, the right to left track hole spacing is _______".

I'm going by memory, but I think I have: A and C as 12.25"
And B as 12.5", and D as 12.0"

Thanks....

 

[green1]

Get the seats and tracks, and measure them.

 

[swing69]

Get the seats and tracks, and measure them.

I have a set of Magnum buckets with sliding tracks, that I need to adapt to the floor. I can fabricate the seat adapters.

I just want to make sure that when I drill the floor, the seat holes will be in the correct place, so if someone wants to installl stock buckets and tracks someday......they will line up.

I don't want to buy tracks just to look at them.

I figure someone out there has a bucket seat car with a bare floor out in the garage. If they could take 2 min. with a tape to get me some dims...that would be awesome.

Mike

 

[RedFish]

The factory buckets mount where the dimples in the floor are. Ray Charles could find them.

 

[swing69]

The factory buckets mount where the dimples in the floor are. Ray Charles could find them.

No he couldn't. He's dead. 8)

Yes...I know there are dimples. I THINK I found them, but there are some spot welds and previous rust, pit marks that make it not so clear.