MidTexCuda
Ancient Member
What do you BB guys set your burnout RPM @. Been out of the game and dont want to start by hurting things.
100 RPM below where it blows up! :-D
Depends on the engine and driveline. I like to get the wheel speed in the 80-90 mph range. Figure out what that would take using tire height, rear gear, trans ratio, etc and set the chip there.
I've got a smallblock,but don't see why the burnout would be any different from a bigblock..i usually start in second gear get the tires spinning,bring it up to about 5000-5500 rpms switch to third,get some real good smoke going then let off and roll forward,i'm a big fan of a long smoky burnouts...:-D
What do you BB guys set your burnout RPM @. Been out of the game and dont want to start by hurting things.
thanks for the help I will start with a 5200 chip. I just didn't want to spin the tires faster than needed to get the tires ready.
any down side to putting it to the floor and let the rev limiter control the rpm? seems to work fine with my Tbrake