CUUDAK
Well-Known Member
Guides are good. Put them in the same as they came out.thought - is the lower guide on all the way? are they new? maybe switch them the inside one and outside one?
Guides are good. Put them in the same as they came out.thought - is the lower guide on all the way? are they new? maybe switch them the inside one and outside one?
Not the same stuff!
They are molded. I just picked mine up today. I was shocked to see that they were made in Germany on 6/13/11 12:57. They are exactly like the ones that were on there too. Not gray but the original black.
Ahh, ok.
I got them on the glass with the retainers/guides. Slid it into the vent window frame and it is toooooo tight and hard to slide. Did you use some powder graphite or something to make it slide easier?? Looks like it is rubbing the felt off near the bottom!
No, but I had someone holding the frame while I installed the glass before it all goes into the door. I removed the glass to check and it rubbed the felt off the bottom. It should be alot smoother imo. Thats why I asked if I should use some powder graphite. I suppose I could use some lithium grease instead. I am gonna run a round wire brush through the channel to see if that helps.humm, is it all mounted in? I would lightly lube in the channel track
Thats why I pulled it back apart. I am gonna run a small round wire brush through the track to see if that will help. There is a small spot of rust inside the track where it meets the top of the door. This could be the issue but where the felt rubbed off isn't close.Something doesn't sound right if it is rubbing the felt off. They shouldn't be that tight. Its hard trying to help over the net.
Im glad you got it! I believe I will need to get those one day. Mine are on their last legs and Im going to have to remove the passenger door glass because the one I have in the car has a bad scratch. I just got a good used door glass to replace the scratched one. The fuzzy might not make it when I take it apart.
Ouch!Mine was in a fire & I need 2 now !!!!
Now I can't get the rear windows to move! Gonna tackle that tomorrow
lube the hell out of the back ones before doing anything to them. I twisted one of mine like a horseshoe.
do you have the service manual? it has a step by step to get the rear glass regulators adjusted and it works like a charm!
http://www.justmopar.com/store.php?crn=217&rn=610&action=show_detail
got these for my 67 cuda and is a set not one for $90. These were the cheapest I found for a pair.
Well ordered a set from YEARONE guess what yep BO:mumum:
Are these the same as A-body's