[WANTED] Drive shaft for a 67 barracuda.

[unicornhole]

Swapping out the 318 for a 340/727/8.75 rear. Looking for a drive shaft.

 

[=Max Wedge=]

What length do ya need?

 

[unicornhole]

What length do ya need?

Not sure. Was hoping I could look up the length before I put it together.

 

[redmay]

Not sure. Was hoping I could look up the length before I put it together.

just did same swap on 67 conv. driveshaft needs to be 48.60 inches in length without yoke

 

[barracudakid]

parts book shows 48.60 with an a833 four speed
44.88 with a 727
center to center of the u joints

 

[unicornhole]

just did same swap on 67 conv. driveshaft needs to be 48.60 inches in length without yoke

Thanks!

 

[unicornhole]

just did same swap on 67 conv. driveshaft needs to be 48.60 inches in length without yoke

Is yours a 727?