johnparts
Slammed 1
Hey guys I'm on a tight a$$ budget and I need to fab up my own mounts. I will be using the stock rubber isolators and doing something similar to the TTI set-up but with some added strength to the passenger side. I have enough steel to do a few set's and I was wondering if anyone would be interested in a set to help me offset the cost of the steel? $75 bucks should cover my time and the steel if you are interested and they will be in bare metal so you can paint them or powder coat them yourselves. I have enough steel to rip out 3-4 sets if you guys want them. Since I will be making them by hand they will take some time But I believe they will be as good or better then the TTI units. PM me if you are interested. I will be using 3/16 plate steel just so everyone knows and I have been a fabricator for 8 years so this wont be a junk job to get er done but they will be pretty nice I'm thinking (for hand made parts anyway)
Just so everyone knows I have a 67-72 K-member in my car and that's all I have to build these off of so I can't build early A mounts (unless these will fit) and I can't make Spool type mounts. Also Spool mounts require bushings which I don't have the money to buy so the price would be drastically higher for spool mounts and I would need a k-member to build them off of.
Just so everyone knows I have a 67-72 K-member in my car and that's all I have to build these off of so I can't build early A mounts (unless these will fit) and I can't make Spool type mounts. Also Spool mounts require bushings which I don't have the money to buy so the price would be drastically higher for spool mounts and I would need a k-member to build them off of.