Welp, So I rewired the whooooooole car and added a spade type fuse block. Before I did all this, I was checking the gauges and as I pulled them out of the dash, the fuel gauge started working fully. Before it would go to 1/4 tank and stop. So I thought maybe bent needle. Nope. Not bent. As I push the cluster back in the dash, it shows correct. Push it almost into place. Then the gauge drops back down. Pull the gauges out an inch, goes back up. Push it back in, goes back down.
So my dilemma is that it did it before the rewiring job, and it still does it now after. I have the new clip at the tank. It's somewhere in the cluster itself. It's not touching anything it doesn't need to touch, all the wires are correct. So does anyone else have this issue?
So my dilemma is that it did it before the rewiring job, and it still does it now after. I have the new clip at the tank. It's somewhere in the cluster itself. It's not touching anything it doesn't need to touch, all the wires are correct. So does anyone else have this issue?