cjh
Well-Known Member
I made a set of engine mounts for my slant 6 to go drag racing.
Nothing was available in Oz for a slant, only a V8, and they want $345 + freight.
I already had some urethane bushings ( free ), and some spare engine mount brackets, just gome some flat bar steel, and some hollow bar steel, and machined that to suit the bushes.
I made the crush tubes from and old shockie shaft, 22mm.
First off, I had to make a frame to hold the engine up while doing the mounts.
Nothing was available in Oz for a slant, only a V8, and they want $345 + freight.
I already had some urethane bushings ( free ), and some spare engine mount brackets, just gome some flat bar steel, and some hollow bar steel, and machined that to suit the bushes.
I made the crush tubes from and old shockie shaft, 22mm.
First off, I had to make a frame to hold the engine up while doing the mounts.
Attachments
-
IMGP3024.jpg78.4 KB · Views: 704
-
IMGP3025.jpg63.8 KB · Views: 618
-
IMGP3031.jpg63 KB · Views: 525
-
IMGP3032.jpg39.2 KB · Views: 480
-
IMGP3033.jpg66.3 KB · Views: 508
-
IMGP3080.jpg57.4 KB · Views: 541
-
IMGP3089.jpg47.1 KB · Views: 468
-
IMGP3091.jpg63.9 KB · Views: 528
-
IMGP3094.jpg58.1 KB · Views: 475
-
IMGP3095.jpg71.4 KB · Views: 480