Bulldozer
free ice cream sandwiches
ive learned a ton here in the last hour , thanks !
So they are all the same? As in valve sizes.
NO!
70-71 will have a 2.02 if from a 340. Any others most likely have a 1.88.
NO!
70-71 will have a 2.02 if from a 340. Any others most likely have a 1.88.
ive learned a ton here in the last hour , thanks !
Ok thanks Cracked you have cleared this up for me. But is it possible some 360s had the 2.02s on them.
this thread should be sticky for everyone to learn from
good stuff here
Anything may be possible... I might fly to the moon unassisted...
Possible???
Probable, certainly not!
That's the reason I said likely. Might there be a 360 that got out with a set of 2.02's, maybe. It's more doubtful than probable.
I thought they were X heads?1970 T/A heads weren't they J heads with 2.02 and the push rods holes moved? My uncle has a set I'm pretty sure they had a J on them last time I'd seen them.
Ok thanks
Yea mopar may have said they never did it but that dont mean they didnt. Just like the Hemi Belvedere I that didnt exist.Remember when I said never say never? lol
......I thought a 71' 360's which were 2bbl's were "J"s with 1.88's and all 71' 340's were "J"s with 2.02's. So that's where i'm at, let the discussion continue.
And "X"s, 68-70 were all 2.02's...........That's my story and i'm stickin' to it.
Ok thanks Cracked you have cleared this up for me. But is it possible some 360s had the 2.02s on them.
1970 T/A heads weren't they J heads with 2.02 and the push rods holes moved? My uncle has a set I'm pretty sure they had a J on them last time I'd seen them.
Yes. T/A heads were J heads with the pushrod holes moved over and T/A cast into the head also to identify them.