Let's see Pic's of your Slant Exhaust!

[TF360]

Let's see your performance exhaust routing. Single and Dual exhaust systems-Headers and hi-po manifolds.

 

[Darter6]

OK.Using Clifford headers.Home made from leftovers.2 1/2''

 

[TF360]

You made that y-pipe Darter?

 

[diymirage]

does slant cut count?

 

[Hyper_pak]

Hyper Pak manifolds, Flowmaster 2.25 to 2.5 Y pipe, 2.5 pipe to a Magnaflow muffler and out before the tire. 62 Lancer Wagon.

 

[TF360]

Nice Hyperpak!

 

[diymirage]

Hyper Pak manifolds, Flowmaster 2.25 to 2.5 Y pipe, 2.5 pipe to a Magnaflow muffler and out before the tire. View attachment 1715528852

before?

 

[Hyper_pak]

Said that wrong, after the tire, but on the side, not out the back.

 

[Darter6]

You made that y-pipe Darter?

Local Hot Rod shop did it.

 

[my68barracuda]

The exhaust under the 83 D150, Dual Dutra's each with 32 inch down pipes, that Y together.
The slant in the D150 was built for low RPM torque, so it is not a high winding slant, this exhaust system gives it a definite growl as the RPM's get above 2500

 

[my68barracuda]

The wrapped Hooker Long Tube Headers in the 68 Barracuda.
When on the strip the headers dumped in to a set of 18 inch extensions. The project for this week is putting a street friendly exhaust system in.