canuckmoparnut
Member
I am brand-spanking new on 'A-bodies Only'. Have found a lot of good advice, but of course need more.
I am in the process of building a B block 500 inch stroker. Machine shop work all done Edelbrock heads installed, Comp Cams roller, 440 Source roller rockers, Comp Cams roller hydraulic lifters. I still have to measure for the pushrods yet.
Still looking for a 67-69 Barracuda or 68-69 Dart to host my motor.
Machine shop/engine builder estimates 600 horses.
Should run good, eh. (Canadian, of course)
I am in the process of building a B block 500 inch stroker. Machine shop work all done Edelbrock heads installed, Comp Cams roller, 440 Source roller rockers, Comp Cams roller hydraulic lifters. I still have to measure for the pushrods yet.
Still looking for a 67-69 Barracuda or 68-69 Dart to host my motor.
Machine shop/engine builder estimates 600 horses.
Should run good, eh. (Canadian, of course)