No hole for a pilot bearing in a 440 crankshaft.What do you do?

[Badvelle-bob]

I could use some info on bearing # to use the converter register for bearing,and cutting the input shaft.I'm sure some of you guys have ran into this problem.Any info would be greatly appreciated.

 

[bOb shingler]

have you considered posting in the 4-speed section?

 

[dano]

You can cut the input shaft length down and run a Dakota (I believe) bearing adapter that goes into the converter snout bore of the crank.

This is what you use for a pilot bearing:

http://www.manciniracing.com/mopibemav8.html