Officially no hope.

[dusted72]

When I got my car it had been stripped inside and the only remaining piece of interior was the head liner. I pulled it down today trying to see if there was a buildsheet, nope. Where would I begin to look for it maybe AlaskanT/A or what. Also I heard something about a punchcard that the factory used to make my car, can that be obtained?

 

[68383GTS]

On the backside of the glovebox liner on topside,under the gas tank.......

 

[dusted72]

None of that stuff is there.

 

[outlawcuda]

One of my cars had one between the trunk and the back seat hard board.

 

[dusted72]

No back seat and no hard board here

 

[daredevil]

open ticket to do it your way

 

[dusted72]

Yep I got the fender tag and the VIN but I just wanted to have it. But either way I considered it a blank canvas. GF3 green /6 auto why even try to go back original?

 

[cudaman51]

so make your own build sheet just the way you want it

 

[whitedawg]

This should get you a build card
http://www.chryslerheritage.com/newsroom.do?id=390&mid=135&mid=146

 

[Alaskan_TA]

Chrysler only has the IBM cards for 1967 models & older.

Everything I have is listed at the link below, if you see your VIN give me a shout;

http://www.hamtramck-historical.com/found.shtml