CudaFactHackJob
Well-Known Member
Next time are you going to rebuild your own?
Well that's cheapskate bullshit. You help a trans with a deep pan, if you also add more fluid & filter extension. That's RediculousThe guy said because I put my deep pan on and not use the one it came with, voids the warranty. I'm going to pull valve body and see if strut just needs to go back in
Copy on that once I get the chance I'll be thorough and post pictures and everythingif, after pulling the valve body, you can see burn marks, or heat discoloration, then the trans will have to be pulled and gone thru. Judging from what you've disclosed already, you might be better off just pulling the trans, and going thru it, again, anyway. It sounds like it was a slap-dash job from the "rebuilder" from the get-go. Document what you see and do, take plenty of pics. If it's as bad as you say, you might want to post it on twitter.
Really?! Damn after it locked up I pulled over and I put it back in first and putted first down the street looking for a turnaround and when I went to turn around I had to make 3 point turn, reverse wouldn't work. Then put it in first and putted it about 500ft back to the house. I sat in the driveway going through the gears and it acted like what it was doing before no engagement to reverse but seemed to go into gear for drive so not sure but that would be awesome if it wasn't destroyed lol. Tranny was 1000 bucks...I'm going to buy a crt valve body cause I have been eyeballing one for awhile but I will report back soon thank u again for the helpHey mark
If the trans tried to lock up on the 1-2 shift , the low rev. Band stuck on, that's what caused the bind.
Rear band will be wiped out and possibly the rear band drum also.
Best bet at this time is to just pull it disassemble and assess damage.
Hope not to bad, good luck.
Lon
Thank you I really appreciate thatMark if I can help with questions give me a pm and will try to help.
Lon
Okay, so I'll hole off on that but yeah it had a deep pan but I had a cast aluminum deep pan. It's like he rebuilt it and threw parts cheap on it. No filter extension on it either. How do I check for bolt in sprag?Sonic should be billet. Says it had a deep pan. Make sure it has a bolt in sprag. Kim
Alright cool I'll just get the valve body thenSonnax low and rev piston should be a billet piston.