Cuda416
Well-Known Member
I'm curious if anyone here uses one of the spot welder style dent pullers that you touch to the area, pull the trigger, then use the built in slide "hammer" to work out the dent.
I've got a door which had a car drop down on it when it was being delivered (dollies punched through the trailer floor.) and dented an otherwise perfect, rust free door. There is a slight creese in the middle of the skin I should be able to work out, but there is a pretty deep dent along the front edge and structure. I was thinking about just getting a stud puller but saw that the spot welder style isn't really that expensive and seems more effective for what I need to do.
Any experiences good/bad are appreciated.
I've got a door which had a car drop down on it when it was being delivered (dollies punched through the trailer floor.) and dented an otherwise perfect, rust free door. There is a slight creese in the middle of the skin I should be able to work out, but there is a pretty deep dent along the front edge and structure. I was thinking about just getting a stud puller but saw that the spot welder style isn't really that expensive and seems more effective for what I need to do.
Any experiences good/bad are appreciated.
