Icetech
Well-Known Member
performer rpm
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
I did a set of sbc heads years ago and used a cheap gasket. Well it was off set and basically trashed the heads. Be sure.
Icetech
Well-Known Member
These are edelbrock 7276's both gaskets line up the same on it
You can tell cruising season is coming. Marketplace is full of classic cars for sale.
Icetech
Well-Known Member
Love that race dart for sale.. but who removes the vin and throws away the clear title.. WTF... no title is a instant no buy when i look at stuff
worth a look its free.
Morning!
-20°,wtf? Think i have had enough….
-20°,wtf? Think i have had enough….
Good Morning All!
Heads won't be here for another 2 monthsGuess i will wait. when i put it together i'm going to be running a scope down to check the fit.. being a dual plane i can't see straight in
There's a decent looking Sport Fury for $8,500... but looks like a bunch of the lower rear quarters were cut away
Alot of no title/engine cars poping up on the tempest searches. Some are like why did you make this a drag car!
So started moving stuff in to the container. Holy crap I think I have the 340 dual point market covered, at least 10 so far. And the coveted tan MADE IN USA dual point caps 8 of them and 6 more on the way. They found me.
Safe travels!
Backread fail here maybe, did you get your dehumidifier welded up?
Had to look that one up, don't have HBOWell.. Succession started up again last night.. so something to watch today
Good Morning everyone. Got some work done on the Charger yesterday. I made the mounts for the front leaf spring hangers....It is officially on 2x4 tube frame bumper to bumper. Some patching on the firewall, then the roll cage starts. I hope all is well
Nice work it's pretty cool you're making that happen!
If the gasket isn’t off, that’s the worst case of shift I’ve seen out of an Edlebrock product
Put a few carriage bolts in and covered the outside with sealant. So much for not drilling it........
Well you have climate control for those electronics, that's a good thing.
Icetech
Well-Known Member
I don't have it either.. i just stream everything... paying for tv is silly to me
Speaking of porting. I have a set of NOS, unused direct connection porting templates for the 906 big block heads. Wondering those are worth anything?
Chris hows your Crypto doing? I am still down a bit.
Why not weld it
-
Similar threads
