ScampMike
Despicable Damn Yankee
biggest issue at this point is that the header is in the way for getting a good swing at anything..
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
ScampMike
Despicable Damn Yankee
tried it with big channel locks with rubber bits on the teeth - nada
That would be a pin in the ***. Cant grab the back of the bar? Why is it coming out?
straightlinespeed
Sometimes I pretend to be normal
Did I miss anything important?
The sun is up.
The neighbor's house.
Peeping Tool!
Wow, we got thumped over nite. 30 inches of snow and 5 foot drifts and still snowing. Inside making blueberry pancakes for me and the wife. Start digging out when it quits snowing. Coffee is on.
LOL Hey, 300,000 views!
300,000 lurkers!
I feel for you we just went through that and it sucks.
Hey Tim!
ScampMike
Despicable Damn Yankee
sorry - ran off to grab some vittles.. yea Ray, my frame stand is in the way there - I'll get this.. determind little bugger I is..
I have tool I can send you
ScampMike
Despicable Damn Yankee
listen here California... LOL :twisted: morning Tim
Blueberry pancakes sound good!
Why do you think I post? LOL I used to live in Indiana, And was stationed in North Chicago, Great lakes navel base. I KNOW cold and snow. Frick that!!!:coffee2:
The only time I had a hard time with this, was rusted in, and I had not losened the adjusters far enough. I had to remove bumb stop to get them out. upper of course. :coffee2:
ScampMike
Despicable Damn Yankee
upper bump stop? for the UCA? how the heck is that in the way?
We have thunder snow!
ScampMike
Despicable Damn Yankee
missed this - you do? as in "correct" removal tool?
Upper bump stop prevents assembly from lowering all the way. If you take them out you will get more room to release pressure on torsion bars.
http://www.forabodiesonly.com/mopar/showthread.php?t=88197 Step number two
http://www.forabodiesonly.com/mopar/showthread.php?t=88197 Step number two
-
Similar threads
