plymouth67
It be a lot cooler if you did...
I bought it from challengergary he is a member here that makes vinyl stripe kits. I believe it's like a 73 stripe
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
MomsDuster
Well-Known Member
There are a few shows and a cruise this weekend, we will see how many if any we make it to. Weather is the biggest factor.
Big local one next weekend that I committed to.
Big local one next weekend that I committed to.
plymouth67
It be a lot cooler if you did...
There are a coupe around but weather looks to be dicey so I may sit these out.
MomsDuster
Well-Known Member
Weather here should be nice except for the heat. No fun driving that jalopy in temps over 90*
R4Sedan
Larry
Ok, nothing usual down here, typical hurricane season getting ready for a another one. Ugh....
he went and edited it, it was 200....
MomsDuster
Well-Known Member
Batten down the hatches! Be safe!
You in the path of Dorion?
R4Sedan
Larry
Thanks MD
guess I need to step away from my Master's thesis study, I didn't know a hurricane was out there
Going to hammer Florida for sure.......
Princess Valiant
A.K.A. Rainy Day Auto
I bet it's a 71 type coming from him.
A 73 is two big lines towards the front like this.
The good thing is they all look great but they are different almost every year
Yeah, was just reading that. Hopefully it wont be as bad as last years
R4Sedan
Larry
I'm on the west coast. As of right now the East Coast is gonna get hammered. But the cone is huge. And those things are unpredictable.
zkx14
Duster De-ruster
Did these banged up moldings come off the same car as the 'like new' tail lights? Not sure if older and newer Dusters take the same moldings. I think I got $40 at Carlisle for a nice 'driver' drip rail set with light removable dings from a ‘74. If NO dents either set will bring about $100+.
Princess Valiant
A.K.A. Rainy Day Auto
That's pretty fancy, my duster never had drip mouldings nor wheel lip mouldings, I must have got a cheap one
my base model dart had them.
I wonder what happens if it cross the Florida main land, stays together as a small hurricane but then hits the warm waters of the Gulf of Mexico?Would that not strengthen it?
zkx14
Duster De-ruster
Vinyl tops always have the drip rail moulding.
I have a friend on the Atlantic coast in Sebastian s.e. of Orlando. No response from him on Facebook. I bet he is prepping for the worst.
plymouth67
It be a lot cooler if you did...
Hey men, posted some wanted parts over at FBBO,
WTB - 1966 Satellite, trim
If anyone here has some........Thanks.
WTB - 1966 Satellite, trim
If anyone here has some........Thanks.
Looking like a direct hit coming to Melborne / Palm Bay FL, right where I have my Winter retreat shack. Wish me Luck !
The saving grace is the Indian River (inner coastal waterway) and the beach side properties on it's East shore. That diffuses the storm surge as the hurricane comes on to land. Atlantic Ocean is one mile out as the crow flies.
Have survived quite a few near misses there over the last 6 years, this time may be a different story. Have the place all batten down good for 120 mile per hour winds, anything more than that I guess I will have to go down and clean up the mess, bring in a travel trailer and hook up to the utilies and good to go again for a while.
Knew this all too well holding property in Florida. Hope it does not have to go to "Plan B".
Looking out North East from the roof top of the Property in Palm Bay . . .
-
Similar threads
