I have to figure out with the roll bar as well.....................
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Make a paper template
Heat up an empty soup can to make circle cuts
Big holes!
I am going to have to slice to enclose them like he did originally....................... I need to take my time with it. I am gone all next week then only a couple of days load up to go to MITP, if I don't get the carpet in no big deal.
Bet fender welting would work to wrap around the roll bar cuts.
or fender lip plastic trim...............
Well....The roll bar requires a big hole. slice it and adjust to the size you need. Cutting a round hole is hard with a knife
Looks close to size of tomato paste can
I'd remove the roll bar. Roll bars are for sissy's and you might as well get rid of the seat belts too. Lighten that car up!
Already no seat belts, but to drag race I need them to run on a track per the rules I believe
Fixed!
A piece of tubing with the end sharpened. In a drill. Works slick! As a bonus, push a pick in from the bottom and its bang on every time.
I use the gasket punches.
Actually I was kidding....just being an agitator.
Unlikely.
Was just kidding, doubt it too, just being an agitator 2
I use a small propane torch and a Philips screwdriver, makes a bigger hole, and go from under the car.I don't have the exact tool however, I did read about heating up an awl to do the same thing.
Barracuda is almost done then start to clean it up a bit. Got a show tomorrow at a tire shop that just opened up in Bennett, one town over.
Speedy Pedi
Well-Known Member
Good Morning working on 1st cup of coffee
I have a large box of this about 300ft. If anyone needs any.
I get it. No problem.
Second one here, still waiting for something to happen lol!
The heavyweights?
-
Similar threads
